Preskoči navigacijo

Stran trenutno ni na voljo v vašem jeziku. Lahko si ogledate strojni prevod, ustvarjen s storitvijo Google Translate. Te storitve ne zagotavljamo mi in rezultatov prevoda nismo preverili.
Za dodatno pomoč se lahko obrnete na nas.

Questions on Renishaw contact tool setters

Below is the list of frequently asked questions for Renishaw's contact tool setting probes.

Q: Tool setter alignment?

A: See either TS27R or OTS installation movies.

Q: How do I measure an off-center tool without approximate tool length input

A: You can't, an approximate tool length is always needed.

Q: How do I measure dia. 0.5 mm small tool?

A: By slowing down the measuring feedrate.

Q: How do I change approach and measuring feedrate?

A: You need to amend the macro software – Contact Renishaw's technical support team for more details.

Q: Can I just do length calibration?

A: No you can't, the calibration cycle will check both length and diameter.

Q: When does the calibration cycle run?

A: Once initial set-up has been completed, the automatic calibration cycle can be run at intervals that suit the machining process requirements.

Q: How long will the batteries in my OTS last?

A: The battery life is listed in the OTS Data sheet.

Q: How do I turn on/off the OTS?

A: The OTS operates using optical on/optical off mode.

If your question hasn't been answered, please contact Renishaw's technical support team.